your browser isnt compatible, please install a up to date browser such as chrome
Please try these tips if you are having trouble programming your MOB1
- Ensure your device's screen is set to maximum brightness
- Disable auto brightness
- Do not try to program MOB1 in direct sunlight or strong artificial light
- If you can't get MOB1 to successfully program using one device, try another device such as a phone or tablet
- If you are using Android or iOS, you can add this webapp to your homepage by clicking on the menu bar and selecting add to home screen
- To delete the MMSI from the MOB1, simply leave the MMSI field blank
Validation Complete!
Next steps:
- Arm the MOB1 by moving the red slider down
- Place the rubber programming adaptor over the MOB1 with the aperture over the strobe LED (as shown in the picture below)
- Press and hold the test button by pressing the raised button on the adaptor for approximately 15 seconds.
- The following LED sequence will complete:
- Flashing red.
- Steady red.
- Slow flashing red.
- Flashing green.
- Release the test button once the LED sequence completes.
- Wait for the green LED to turn off and then select 'Program MOB1' below. On the next screen, position the MOB1 over the flashing box with Programming adaptor held against the screen.
Note: The MOB1 will automatically power off if it does not receive screen communication within 30 seconds.
Please enter your MMSI into the box below, and select any DSC options you want to enable
Please validate your MMSI('s) by entering them again
Are you sure you want to delete your MMSI? Press Validate to continue
Programming will begin in 5 seconds, hold MOB1 in place
MMSI invalid, please ensure its a real MMSI, is numerical only and exactly 9 digits long
Group MMSI invalid, please ensure its a real MMSI, is numerical only and exactly 9 digits long
If MOB1 is flashing green, programming has been successful.
If MOB1 is flashing red, please try again.
The MMSI's you entered do not match.
The Group MMSI's you entered do not match.
0%